Home > Products > Crimping and Stripping > PA-24
PA-24 Micro Connector Crimping Pliers
More than 170 different terminals applicable
-
Specialty of 2.5mm pitch connector contacts of different connector manufacturers, works with JST XH, PH, EH & NH series, Molex Micro-Fit, KK series, etc. AWG #32-#18
-
Perfectly crimps triangular insulation barrel (lugs) of DuPont (Servo) connector, Molex C-Grid III, etc. without damaging the insulations.
-
6 Crimping Dies ('m'-shaped crimp: 1.3, 1.6, 1.9 & 2.2mm in width &
Round crimp: φ1.4 & φ1.8mm) for open-barrel contacts -
Built-in screw cutter (M2, M2.6 & M3)
-
Tapered and slender jaws, Light weight of 115g only
-
Spring loaded (on the back side), with locking latch for easy handling
Click here! [Crimp Contact Application Chart]
JST Crimp Contacts
Video
Features
M-shaped Dies [1.3, 1.6, 1.9 & 2.2mm in width]
The conductor barrel can be crimped securely. The insulation barrel can be curled up very tidily.

Round Dies (For DuPont contact etc.) [φ1.4 & φ1.8mm]
Wrap triangular lugs of the barrel around the insulation without damage.




Screw Cutter M2, M2.6 & M3
Related Products
Line-up of Super Precision Crimping Pliers for open barrel terminals
How to select the suitable crimping dies

1. Measure the width of conductor barrel or insulation barrel with
a caliper while both barrel lugs are adjusted in parallel.

2. Select the die width that is close to the width of barrel lugs measured. Example: 1.5mm measured -->> Select 1.6mm dies.
3.
Conductor Barrel (Lug) Crimping :
It is better to offset the rearmost edge of conductor barrel (lug) 0.1-0.2 mm from the edge of the upper die to form a bellmouth on the edge of the crimped barrel. (as per the figure on the right)
Insulation Barrel (Lug) Crimping :
Set the insulation barrel (lug) at the center of the upper die in depth to keep the barrel (lug) horizontal when crimping.
.jpg)
Specifications


